Table of Contents
Advertisement
Level 1 and 2 Service Manual
Replacing the Transceiver Board
G
6809471A67-O
3.
Remove the flex from the ZIF connector to disconnect from the transceiver
board. The Delrin tweezer or EMEA flexprint removal tool may be used to assist
with disconnecting the flex, if necessary, as shown in Figure 12.
Figure 13. Removing the Transceiver Board
4.
Carefully lift the transceiver board from the front housing as shown in
Figure 13.
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
1.
Insert the transceiver board into the front housing with the ZIF connector on
top. Ensure the keypad PCB is properly aligned with the keypad.
2.
Insert the flex squarely into the ZIF connector on the transceiver board and
close the connector latch until it locks into position.
3.
Replace the rear housing, light guide, antenna battery, and battery cover as
described in the procedures.
August 20, 2003
Transceiver Board
Front Housing
Disassembly
031733o
33
Advertisement
Table of Contents
Troubleshooting
