Removing And Replacing The Keypad Pcb - Motorola V150 Service Manual

Level 1 and 2 Service Manual
G

Removing and Replacing the Keypad PCB

6809471A67-O
microphone will fit into the board only one way. Ensure the microphone
assembly is fully seated against the PCB.
Do not force the microphone into its socket. The connector is keyed to fit only one way.
1. Remove the battery cover, battery, antenna, light guide, rear housing, and
transceiver board as described in the procedures.
2. While holding the transceiver board stationary, carefully pull the keypad PCB
straight away from the transceiver board to disconnect as shown in Figure 15.
The disassembly tool may be used to carefully pry the keypad PCB away from
the transceiver board, if necessary.
Keypad PCB
Figure 15. Removing the Keypad PCB
3. To replace, align the connector on the keypad PCB with the mating connector
on the transceiver board. Firmly press the two board assemblies together until
the connectors snap into place.
August 20, 2003
Keypad PCB Connector
Disassembly
031801o
35