Removing And Replacing The Transceiver Board Assembly - Motorola V360 Service Manual

Level 1 and 2 Service Manual

Removing and Replacing the Transceiver Board Assembly

G
6809493A69-O
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
1. Remove the battery cover, battery, SIM, antenna cap, and rear housing as
described in the procedures
2. Use the disassembly tool to unseat the display flex connector from its socket
(see Figure 8).
Display Flex
Connector
Figure 8. Removing the Transceiver PC board Assembly
3. To replace, align the transceiver board assembly to the phone.
4. Carefully place the transceiver board assembly into the front housing.
5. To replace, carefully align the flex connector to it's socket on the transceiver
PC board assembly, then gently press down on the flex connector until properly
seated in its socket.
6. Replace the rear housing, SIM, battery, and battery cover as described in the
procedures.
.
Transceiver PC Board
Assembly
May 18, 2005
Disassembly
Disassembly
Tool
050324o
27