Repair Manual
Wiring Cable 5 (blue)
Micro Switch
Shutter Button
Figure 4-11 Unsoldering the Wiring Cables
Installation
1.
Solder Wiring Cable 5 (blue wire) to the Micro Switch and Wiring Cable 4
(black wire) to the Lag Terminal.
2.
Tape the wires to the Baffle. (see "Removing the Hot Shoe," page 46)
3.
Install the Shutter Frame by securing the four small phillips panhead
tapping screws.
4.
Slide the Divider Plates into the Baffle. (see "Removing the Hot Shoe,"
page 46)
5.
Install the Camera Back. (See "Removing the Camera Back," page 44)
6.
Install the Exposure Box. (see "Removing the Exposure Box," page 43)
55
ID-200 Camera
Wiring Cable 4
(black)
Lag Terminal