Figure 4-16 Synchro Contact Making Contact With Wheel - Polaroid ID-200 Repair Manual

Repair Manual
Synchro Contact

Figure 4-16 Synchro Contact Making Contact with Wheel

Installation
1. Attach the Synchro Contact and contact washer to the Driver Plate with
the phillips screw and contact collar.
Note: Slowly press the Release Lever while checking to make sure
the Wheel makes contact with the Synchro Contact (Figure 4-16). If
not, bend the contact wire slightly until contact is made.
2. Solder Wiring Cable 3 to the flash Synchro Switch.
3. Install the Shutter Assembly. (See "Removing the Shutter Assembly,"
page 54)
Wiring Cable 3
60
ID-200 Camera
Wheel
Contact Wire