Figure 4-14 Removing The Micro Switch And/Or Assembly - Polaroid ID-200 Repair Manual

Repair Manual
Micro Switch
Driver Plate

Figure 4-14 Removing the Micro Switch and/or Assembly

Installation
1. Secure the Switch Washer Plate to the Driver Plate with the two phillips
screws, washer and Lag Terminal.
2. Secure the Micro Switch to the Switch Washer Plate with the two phillips
screws and washers.
3. Solder Wiring Cable 3 to the Micro Switch.
4. Install the Shutter Assembly. (See "Removing the Shutter Assembly,"
page 54)
Phillips Panhead Screws (2)
Flat Head Washers (2)
Phillips Bindinghead
Screws (2)
58
ID-200 Camera
Lag terminal
Flat Head Washer
Switch Washer
Plate