Quick Features Setup Guide - Philips Magnavox REM400 User Manual

QUICK FEATURES SETUP GUIDE

This guide is provided here for your conve-
nience as a quick reference for performing
remote control sequences.
Component Setup
Turn on Press component
component
(e.g., TV).
1
Auto Scan
Turn on Press component
component
(e.g., TV).
* NOTE: Not VOL+, VOL-, EXIT, SCAN, or SET.
1
Code Verification
Press component
key once
(e.g., TV).
1
Volume Lock
Press component*
key once (e.g., CBL).
* NOTE: Component must have
volume capabilities.
1
12
key once until Red Light
(e.g., TV).
2
key once until Red Light
(e.g., TV).
2
x 2
Press SET
until Red Light
blinks twice;
release SET.
2
until Red Light
If you need more details, reread the full
instructions presented in earlier pages.
x 2
Press SET Enter 4-digit code
blinks twice; Red Light blinks
release SET. twice after last #.
3
x 2
Press SET Aim remote control
blinks twice; press SCAN once.
release SET. When off, press any
3
x 2
Enter 9-9-0;
the Red Light
will blink twice.
3
x 2
Press SET
blinks twice;
release SET.
2
# # # #
x 2
for your brand;
4
at component;
key* to stop.
4
Press 1 once for 1st digit.
Wait 3 sec. and count blinks.
Number of blinks equals
value of code digit.
Repeat with 2, 3, and 4.
4
Press VOL+ once.
Volume now controlled
through component
selected in step 1.
Press POWER
once; if no
response,
repeat steps
with next code.
5
x 2
Press SET
until Red Light
blinks twice;
release SET
to lock code.
5
3