Philips Magnavox REM400 User Manual page 6

PROGRAMMING YOUR REMOTE CONTROL (continued)
Programming A TV/VCR Combo
Perform the following instructions to have
the DSS control a TV/VCR Combo. For
Sharp and Sony models, also see page 14.
IMPORTANT: Please completely read and
review these steps before proceeding. Highlight
the code (on page 17) for the brand you wish to
program or write it down in the supplied chart.
Setup Code For My Component
TV/VCR
1. Manually turn on the TV/VCR
Combo; insert a video cassette.
2. On the remote control, press VCR
once.
3. Press and hold SET until the red
light blinks twice, then release
SET.
4. Use the Setup Codes For TV/VCR
Combos (on page 17) to find the
brand name.Enter the first four-
digit code for your component.If
performed correctly, the red
light will blink twice.
5. Aim the remote control at the
TV/VCR Combo. Press POWER
once. It should turn off. If it does
not respond, repeat steps 2-3,
trying each code for your brand
until you find one that works. If
it still doesn't work, use Auto
Scan (later on this page) to pro-
gram your TV/VCR combo.
NOTE: If the TV/VCR Combo
does not have a Power key, press
PLAY on the DSS.
6. If you've located a TV/VCR code
that works, but it has a separate
TV code, you'll also need to pro-
gram it into the remote control to
access volume control as follows:
a.
b.
c.
6
Press TV once.The red
light will blink twice.
Press and hold SET
until the red light
blinks twice, then
release SET.
Enter the TV code for
the TV/VCR Combo.
If performed cor-
rectly, the red light
will blink twice.
6. (continued)
If there is no separate TV code
listed, you will need to perform
the following steps to access vol-
ume control:
a.
b.
c.
Programming With Auto Scan
If your component does not respond to the
remote control after trying all codes listed for
your brand,or if your brand is not listed at all,
try searching for your code using Auto Scan.
For example, to search for a code for a TV:
1. On the remote control, press TV
once.
2. Press and hold SET until the red
light blinks twice,then release SET.
3. Aim the remote control at the TV
and press SCAN.The red light will
blink twice.
4. Continue aiming the remote con-
trol at the TV (which may take up
to 5 minutes) until it turns off.
Immediately press any key except
VOL+, VOL–, EXIT, SCAN, or SET.
NOTES: In the search mode, the
remote will send IR (infrared)
codes from its library to the
selected device, starting with the
most popular code first.
If you have passed by the code
that turns off the TV, press VOL–
one or more times until the TV
turns on again.
5. To lock in the code and exit Auto
Scan, press and release SET the
red light will blink twice.
6. To search for codes of other com-
ponents, repeat steps 1 through
5, but substitute the appropriate
key (e.g., VCR, CBL, AUD, DSS, or
CD) for the (VCR, Cable, Audio,
Satellite, or CD) component you
are searching for.
Press VCR once.
Press and hold SET
until the red light
blinks twice, then
release SET.
Press VOL +.