Setting The Front Panel Locks (Executive Modes) - Extron electronics DTP CrossPoint 108 4K User Manual

Setting the Front Panel Locks (Executive Modes)

The matrix switcher has three levels of front panel security lock that limit the operation of the
switcher from the front panel. The three levels are:
Lock mode 0 — The front panel is completely unlocked. All front panel functions are
•
available.
Lock mode 1 — All changes are locked from the front panel (except for setting Lock
•
mode 2). Some functions can be viewed.
Lock mode 2 — Basic functions are unlocked. Advanced features are locked and can
•
be viewed only.
NOTE: The switcher is shipped from the factory in Lock mode 2.
Basic functions consist of:
Making ties
•
Recalling presets
•
Changing Lock modes
•
Advanced functions consist of:
Configuring the TP insertion ports
•
Configuring the input audio
•
Setting the rear panel remote port baud rate
•
Selecting Lock mode 2 or toggling between mode 2 and mode 0
NOTE: If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2. The
,
Esc Video
If the switcher is in Lock mode 2, this procedure selects mode 0 (unlocks the
switcher). The
Toggle the lock on and off by pressing and holding the
the
Audio
Lock mode 2
ENTER
Press and hold for 2 seconds.
Lock mode 0
ENTER
Press and hold for 2 seconds.
Figure 25.
, and buttons blink twice.
Audio
and buttons blink twice.
Video Audio
button simultaneously for approximately 2 seconds (see figure 25).
CONTROL I/O
PRESET VIEW ESC VIDEO AUDIO
CONTROL I/O
PRESET VIEW ESC VIDEO AUDIO
Toggling Front Panel Lock Between Mode 2 and Mode 0
DTP CrossPoint 4K Series Matrix Switchers • Operation
button, the
Enter
I/O
VIDEO AUDIO
CONTROL I/O
ENTER PRESET VIEW ESC VIDEO AUDIO
button, and
Video
43