Fast Ethernet Ports; Sfp Optic Ethernet Ports - Siemens RUGGEDCOM RX1400 Installation Manual

Chapter 3
Communication Ports
Section 3.1

Fast Ethernet Ports

The RX1400 features four 10/100Base-TX fast Ethernet (FE) ports with RJ45 connectors. The RJ45 connectors
are directly connected to the chassis ground on the device and can accept CAT-5 shielded twisted-pair (STP)
cables.
For technical specifications, refer to
Each port features an LED that indicates its link state.
State
Green (Solid)
Green (Blinking)
Off
The following are the pin-out descriptions for the RJ45 connectors:
8
Figure 11: RJ45 Ethernet Port Pin Configuration
Section 3.2

SFP Optic Ethernet Ports

The RX1400 features two 1000Base-FX Small Form-Factor Pluggable (SFP) optic Ethernet ports with LC (Lucent
Connector) connectors.
For technical specifications, refer to
IMPORTANT!
Make sure the Transmit (Tx) and Receive (Rx) connections of each port are properly connected and
oriented within the SFP cage to establish a proper link.
16
Section 4.3, "Fast Ethernet Port
Description
Link established
Activity
No link detected
1
Section 4.5, "SFP Optic Ethernet Port
Specifications".
Pin 10/100Base-TX
1 RX+
2 RX-
3 TX+
4 Reserved (Do Not Connect)
5 Reserved (Do Not Connect)
6 TX-
7 Reserved (Do Not Connect)
8 Reserved (Do Not Connect)
Specifications".
RUGGEDCOM RX1400
Installation Guide
Description
Receive Data+
Receive Data-
Transmit Data+
Transmit Data-
Fast Ethernet Ports