Installing The Device - Siemens RUGGEDCOM RX1400 Installation Manual

RUGGEDCOM RX1400
Installation Guide

Installing the Device

This chapter describes how to install the device, including mounting the device, connecting power, and
connecting the device to the network.
WARNING!
Radiation hazard – risk of serious personal injury. This product contains a laser system and is
classified as a CLASS 1 LASER PRODUCT. Use of controls or adjustments or performance of
procedures other than those specified herein may result in hazardous radiation exposure.
DANGER!
Electrocution hazard – risk of serious personal injury and/or damage to equipment. Before performing
any maintenance tasks, make sure all power to the device has been disconnected and wait
approximately two minutes for any remaining energy to dissipate.
IMPORTANT!
This product contains no user-serviceable parts. Attempted service by unauthorized personnel shall
render all warranties null and void.
Changes or modifications not expressly approved by Siemens Canada Ltd. could invalidate
specifications, test results, and agency approvals, and void the user's authority to operate the
equipment.
IMPORTANT!
This product should be installed in a restricted access location where access can only be gained by
authorized personnel who have been informed of the restrictions and any precautions that must be
taken. Access must only be possible through the use of a tool, lock and key, or other means of security,
and controlled by the authority responsible for the location.
The general procedure for installing the device is as follows:
1. Mount the device to a rack, panel or DIN rail.
2. Connect power to the device and ground the device to safety Earth.
3. Connect the LTE and/or GPS antennas.
4. Connect the failsafe alarm relay.
5. Connect the device to the network.
These steps, and other related information, are described in the following sections:
• Section 2.1, "Required Tools and Materials"
• Section 2.2, "Mounting the Device"
• Section 2.3, "Connecting Power"
• Section 2.4, "Installing the Antennas"
• Section 2.5, "Installing the SIM Cards"
• Section 2.6, "Connecting the Failsafe Alarm Relay"
• Section 2.7, "Connecting to the Device"
Chapter 2
Installing the Device
5