Night Light Tm Replacement; Bulb Replacement; Lens Assembly Installation; Lens Assembly Replacement - Napoleon GDS26P-1 Installation And Operating Instructions Manual

(such as Scotch-Brite™) to remove any oxides. Clean the pilot assembly using a vacuum with a soft
brush attachment. It is important that the pilot assembly is not painted.
• Inspect all accessible gaskets and replace as required.
• Access the blower, if equipped and clean using a soft brush and vacuum.
• Re-assemble the various components in reverse order.
• Inspect the relief system. The appliance relieves through the main glass door or through the fl aps on the
fi rebox top. Ensure they open freely, and close sealed.
• Check the gas control valve pilot and Hi / Lo knobs move freely (if equipped) – replace if any stiffness in
movement is experienced.
• Check for gas leaks on all gas connections up and downstream from the gas valve including the pilot
tube connections.
10.2 NIGHT LIGHT
TM

10.2.1 BULB REPLACEMENT

The GDS26-1 comes equipped with our "Night Light™". If in the event the lamp or lens
needs to be replaced, follow these instructions.
A.
Turn off all electrical supply.
B.
Remove the safety barrier front and door from the firebox.
C.
Unscrew the lens cover making sure the washer stays in place.
NOTE: Do not handle the lamp (bulb) with bare fingers, protect with a
clean dry cloth.
D.
The lamp will pull straight out of the socket. Replace with Wolf Steel Ltd. parts only (W387-0006), as lamp
and lens are special "high temperature" products.
E.
Replace lens with gasket, lens covers, attach wires to quick connects and replace the door when finished.
NOTE: The firebox must be sealed.
When re-assembling the light assembly, care must be taken. "Light Leakage" from above the cast doors
may be noticed. The holes in the lamp housing are necessary for ventilation and must not be covered.

10.2.2 LENS ASSEMBLY INSTALLATION

A.
Remove the safety barrier and door from the firebox.
B.
Run the wires up through the lens hole.
C.
Align key hole with lens assembly.
D.
Snap into place.
E.
Replace light shields, attach the wires and replace the door to the firebox.

10.2.3 LENS ASSEMBLY REPLACEMENT

A.
Remove the safety barrier and front door and top shield from the
firebox.
B.
Compress the retainer fins in with a screw driver while pressing firmly on
the top of the light assembly.
C.
Once all the retainer fins are pushed in the lens assembly will snap out
of place.
10.3

CARE OF GLASS

DO NOT CLEAN GLASS WHEN HOT! DO NOT USE
ABRASIVE CLEANERS TO CLEAN GLASS.
Buff lightly with a clean dry soft cloth. Clean both sides
of the glass after the fi rst 10 hours of operation with a
recommended fi replace glass cleaner. Do not use an
ammonia-based fi replace glass cleaner. Thereafter clean
as required. If the glass is not kept clean permanent
discoloration and / or blemishes may result.
This appliance is factory equipped with 5mm ceramic glass. Use only replacement parts as supplied by the
appliance manufacturer. DO NOT SUBSTITUTE MATERIALS.
REPLACEMENT
37.1E
KEY HOLE
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
5.1A
AVERTISSEMENT
!
5.5.1A
LA VITRE CHAUDE CAUSERA
DES BRÛLURES.
NE PAS TOUCHER LA VITRE
W415-2183 / B / 02.10.17
AVANT QU'ELLE AIT REFROIDI.
NE JAMAIS LAISSER LES
ENFANTS TOUCHER LA VITRE.
43
EN