Door Glass Replacement; Log Placement - Napoleon GDS26P-1 Installation And Operating Instructions Manual

6.2

DOOR GLASS REPLACEMENT

CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
Replacement glass/frame assembly shall be replaced as a complete unit as supplied by the
appliance manufacturer.
6.3

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
In order to assemble the log set, the glass door must be removed, see "GLASS DOOR INSTALLATION AND
REMOVAL"section.
A.
Place the rear log as shown, ensuring the
holes on the underside are placed onto the
two pins of the log support.
C.
Place the center log as shown, follow
contour of burner and ensure port holes are
not covered.
!
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
APPLIANCE BEFORE OPERATION.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
!
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
BRACKET
WARNING
56.1C
WARNING
B.
Place the left log as shown, ensuring the hole
on the underside is placed onto the burner
pin. This will rest on the left side of the rear
log.
D.
Place the hole in the underside of the right
log onto the locating pin, on the burner base
and rests against the rear log as shown.
E.
Reinstall the glass door.
33
76.1A
W415-2183 / B / 02.10.17
EN