Maintenance; Night Light Tm Replacement; Bulb Replacement; Lens Assembly Installation - Napoleon Vittoria GD19N Installation And Operating Instructions Manual

46
11.0

MAINTENANCE

TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper
and dangerous operation. Verify proper operation after servicing. This fi replace and its venting system
should be inspected before use and at least annually by a qualifi ed service person. The fi replace area must
be kept clear and free of combustible materials, gasoline or other fl ammable vapors and liquids. The fl ow of
combustion and ventilation air must not be obstructed.
1. In order to properly clean the burner and pilot assembly, remove the logs, rocks and/or glass to
expose both assemblies.
2. Keep the control compartment, media, burner, air shutter opening and the area surrounding the logs
clean by vacuuming or brushing, at least once a year.
3. Check to see that all burner ports are burning. Clean out any of the ports which may not be burning or
are not burning properly.
4. Check to see that the pilot fl ame is large enough to engulf the fl ame sensor and/or thermocouple /
thermopile as well as reaches the burner.
5. Replace the cleaned logs, rocks or glass. Failure to properly position the media may cause carboning
which can be distributed in the surrounding living area.
6. Check to see that the main burner ignites completely on all openings when turned on. A 5 to 10
second total light-up period is satisfactory. If ignition takes longer, consult your local authorized dealer /
distributor.
7. Check that the gasketing on the sides, top and bottom of the door is not broken or missing. Replace if
necessary.
8. If for any reason the vent air intake system is disassembled, re-install and re-seal per the instructions
provided for the initial installation.
11.1 NIGHT LIGHT
11.1.1

BULB REPLACEMENT

The GD19 comes equipped with our "Night Light™". If in the event the lamp or lens
needs to be replaced, follow these instructions.
A. Turn off all electrical supply.
B. Remove the front and door from the fi rebox.
C. Unscrew the lens cover making sure the washer stays in place.
NOTE: Do not handle the lamp (bulb) with bare fi ngers, protect with a
clean dry cloth.
D. The lamp will pull straight out of the socket. Replace with Wolf Steel Ltd. parts only (W387-0009), as lamp
and lens are special "high temperature" products.
E. Replace lens with gasket, lens covers, attach wires to quick connects and replace the door when fi nished.
NOTE: The fi rebox must be sealed.
When re-assembling the light assembly, care must be taken. "Light Leakage" from above the cast doors
may be noticed. The holes in the lamp housing are necessary for ventilation and must not be covered.
11.1.2

LENS ASSEMBLY INSTALLATION

A. Remove the door from the fi rebox.
B. Run the wires up through the lens hole.
C. Align key hole with lens assembly.
D. Snap into place.
E. Replace light shields, attach the wires and replace the door to the fi rebox.
11.1.3

LENS ASSEMBLY REPLACEMENT

A. Remove the front door and top shield from the fi rebox.
B. Compress the retainer fi ns in with a screw driver while pressing fi rmly on
the top of the light assembly.
C. Once all the retainer fi ns are pushed in the lens assembly will snap out of
place.
W415-0825 / 07.06.09
MAINTENANCE
MAINTENANCE
MAINTENANCE
REPLACEMENT
TM
WARNING
!
40.1
KEY HOLE