Top Cover Removal; Bottom Cover Removal - Canon EOS 5D Service Manual

＜Disassembly Procedure＞

Top Cover Removal

⑴ Remove the axial screw and the Diopter Correction Dial.
⑵ Remove four screws (one on top, two below, and one at the rear) and gently lift the top cover.
⑶ Disconnect the connector and gently lift the top cover off.
Fig. 035 Top Cover Removal 1

Bottom Cover Removal

⑴ Remove the Cable Door.
⑵ Remove five screws at the bottom and one at the top and remove the bottom cover.
Fig. 038 Bottom Cover Removal 1
＜Reassembly Notes＞
NOTE 1
⑴ Make sure that the lead wire runs under
the nut lug.
Fig. 040 Top Cover Installation Caution 1
Fig. 036 Top Cover Removal 2
Fig. 039 Bottom Cover Removal 2
⑵ Make sure that the OLC Flex to LPU
circuit board is clean and nothing is
caught in it when the connection is made.
Fig. 041 Top Cover Installation Caution 2
15
Repair Information
Fig. 037 Top Cover Removal 3