Tool Battery Fabrication; Required Parts; Expendables List - Canon EOS 5D Service Manual

Expendables List

New Name
Light-shield tape
Scotch tape (No. 315)
Double-sided tape
Aron Alpha 201
Arontite L
Three Bond 1401C
UTLM-10
Silicon KE347B
Humi-Seal 1B-66
Grease IF-10
Variator SJF-102
Logenest Lambda A-74
Cemedine Super X8008B
Nox Guard ST-420
Logenest Lambda NFH-743C
Diabond 1663G
Friction Inhibitor [hf1] 923

1.6 Tool Battery Fabrication

Required Parts

⑴ CY9-1101-000 Tool Battery Probe Kit
⑵ DY9-1374-000 Charge Adjustment Tool
Fabrication Procedure
⑴ Prepare the aformentioned products.
⑵ Remove the leads soldered to DY9-1374, and solder the CY9-1101lead wires to the battery
contacts, and put the wires through the hole in the battery cover.
⑶ Solder banana plugs to the end of the leads.
⑷ Tape the tool battery covers together.
DY9-1374-000
After installing the
leads as shown at
the right, close the
battery covers.
Part No.
CY9-4026-000
CY9-4031-000
CY9-4034-000
CY9-8007-000
CY9-8008-000
CY9-8011-000
CY9-8031-000
CY9-8064-000
CY9-8069-000
CY9-8088-000
CY9-8100-000
CY9-8102-000
CY9-8118-000
CY9-8123-000
CY9-8125-000
CY9-8129-000
DY9-3042-000
(2)
(1)
Finished Kludge
Fig. 014
6
Repair Information
Purpose/Subject
M2 motor
―
Adhesive for body
Securing SPD and SI in place
Screw heads
Screw lock
Mirror parts
Water resistance
Moisture-proof insulation
Mount Spring Friction surface
Parts assembly
M2 gear shafts
Mount ring adhesion, etc.
Parts assembly
Front cover's friction surfaces
Adhesive for parts
Flex pattern