Belts - Gravely pro-stance 36 994131 Operator's Manual

Adjust Parking Brake
(Figure 24)
1. Disengage parking brake.
2. Loosen jam nut on parking brake cable
adjuster and pull down on adjuster barrel
until cable is taut, not tight.
3. Thread bottom nut until it contacts
bracket.
4. Tighten the top jam nut.
1. Jam Nut
2. Parking Brake Cable Adjuster
Figure 24
5. Engage parking brake and check
adjustment. Repeat as needed.
6. Set both bypass levers to drive position
after brake adjustment.

BELTS

WARNING: Moving parts can cut
or amputate body parts. ALWAYS
wait for moving parts to stop
before performing maintenance or
service.
CAUTION: Damaged or worn
belts may result in injury and/or
damage to unit. Check belts for
excessive wear or cracks often.
Belt Access
(Figure 25)
1. Stop unit, engage parking brake, remove
key and wait for moving parts to stop
and hot parts to cool (see Operation on
page 12).
2. Open front belt access panel.
3. Lower the mower deck.
4. Loosen retaining knobs on left and right
belt guards and remove belt guards from
deck.
1
2
1. Belt Access Panel
2. Belt Guards
PTO Mower Belt Replacement
(Figure 27 and Figure 28)
1. Gain access to belts (see Belt Access on
page 28).
2. Remove transmission belt (see
Figure 28).
3. Release tension from idler pulley.
4. Remove PTO mower belt from clutch
and then from sheaves.
5. Install new PTO mower belt on clutch
and then on sheaves.
EN - 28
CAUTION: Use care when
releasing idler spring tension.
Keep body parts well away from
idlers when performing this
operation.
2
1
Figure 25