Travis Industries DVS Insert EF II Owner's Manual page 19

b
Line up each side surround
panel and insert two screws from
the outside to secure in place.
NOTE:
These 3/8"
stand-offs are
not required
and may be
flattened.
a
Install the top panel so the
two tabs insert into the slots
on the side panels.
The insulation included with the
Top Trim
panels may be discarded.
Top
Panel
Pre-thread the holes on the surround
a
panels with the screws included in the
surround panel kit.
5/16" Nutdriver
NOTE:
These 3/8" stand-offs are not required
and may be flattened (both sides).
Construct the panel trim. Insert one leg of each "L"
b
bracket into the top and side trim piece. Align the
trim to form a precise corner, then tighten the two set
screws with a small standard screwdriver. Slide the
trim over the panels.
"L" Bracket
Slot for on/off
Top Trim
switch and hole
for rheostat
Right Side Trim
Right Side
Trim
Run the rheostat wires,
on/off switch wires, and
power cord through the
access hole on the insert
Tighten the set
screws from the back
side with a small
standard screwdriver
"L" Bracket