Advertisement
Make sure power to the heater has been turned off prior to installation (unplug the power cord).
Do not connect 110-120 VAC to the gas control valve or the on/off circuit on this fireplace.
NOTE: To prevent heat-damage to the
wires, make sure this clip holds the
wires down, away from the burner.
NOTE: On the DVS, make
sure to use the lower screw.
Remove this screw, position the
a
accent light assembly in the same
location, and attach with the same
screw.
Remove this cover plate and
b
gasket.
NOTE: The cover plate is
here on the DVS.
NOTE: Once the light is in
place, remove the protective
covering. Do not touch the
halogen bulb - this may lead to
premature bulb failure.
Route the wires from the accent
a
light through the gasket and
firebox floor. Use the screws
removed in step "2" to attach the
wire plate to the firebox floor
(make sure the gasket is
properly aligned).
Wire Plate
Once the wire plate is in
place, pull the excess
b
wire through the
grommet, towards the
front of the insert.
Advertisement
