Configuring Transmission
6
Routing Configurations
With routing configurations, you can:
Configure the static routing
Configure the policy routing rule
View the routing table
6.1 Configuring the Static Routing
Choose the menu Transmission> Routing > Static Route and click Add to load the
following page.
Figure 6-1 Configuring the Static Routing
Specify the name of the static route entry and configure other related parameters. Then
click OK.
Name
Destination IP
Subnet Mask
Next Hop
Interface
Enter a name for the static route entry.
Specify the destination IP address the route leads to.
Specify the subnet mask of the destination network.
Specify the IP address to which the packet should be sent next.
Specify the physical network interface through which this route is accessible.
Routing Configurations
Configuration Guide
70