TP-Link TL-R470T Plus Configuration Manual page 71

Configuring Transmission
Figure 3-2 Add Bandwidth Control rules
Specify the name of the Bandwidth Control rule and configure other related parameters.
Then click OK.
Direction
Group
Maximum
Upstream
Bandwidth
Maximum
Downstream
Bandwidth
Mode
Effective Time
Description
ID
Status
Specify the data stream direction for the rule.
Specify the address group for the rule to define the controlled users. The IP group
referenced here can be created on the Preferences > IP Group > IP Group page.
Specify the Maximum Upstream Bandwidth in Kbps for the rule.
Specify the Maximum Downstream Bandwidth in Kbps for the rule.
Specify the bandwidth control mode for the address group.
Individual means the bandwidth of each user is equal to the current bandwidth of
this entry.
Shared means the total bandwidth of all controlled IP addresses is equal to the
current bandwidth of this entry.
Specify the time for the rule to take effect. Any means it always takes effect. The
time range referenced here can be created on the Preference > Time Range >
Time Range page.
Enter a brief description for the rule.
Append the rule to the right position to give a priority for the rule.
Check the box to enable the rule.
Bandwidth Control Configuration
Configuration Guide 64