Configuring Mac Filtering - TP-Link TL-R470T Plus Configuration Manual

Configuring Firewall

2.3 Configuring MAC Filtering

To complete MAC Filtering configuration, there are two steps. First, add MAC Filtering entries
to the MAC Filtering List. Then configure the filtering rule for these entries.
Note:
In case MAC Filtering causes access problems to the currently connected devices, it's recommended
to add and verify the MAC Filtering entries first before configuring the filtering rule.
Choose the menu Firewall > MAC Filtering > MAC Filtering to load the following page.
Figure 2-3 MAC Filtering
Follow the steps below to configure MAC Filtering:
1) In the MAC Filtering List section, click Add to add MAC Filtering entries to the MAC Filtering
list. Specify a name and enter the MAC address in the format xx-xx-xx-xx-xx-xx. Click OK.
Figure 2-4 MAC Filtering
2) In the General section, enable MAC Filtering and select the filtering rule. Click Save, and the
filtering rule will be applied to all entries in this list.
Enable MAC Filtering Check the box to enable MAC Filtering.
Firewall Configuration
Configuration Guide 92