Snmp - TP-Link TL-R470T Plus Configuration Manual

System Tools
4

SNMP

Choose the menu System Tools > SNMP > SNMP to load the following page.
Figure 4-1 Configuring SNMP
Follow these steps to configure the SNMP function:
1) Check the box to enable the SNMP function.
2) Configure the following parameters and click Save.
Contact
Device Name
Location
Get Community
Get Trusted
Host
Set Community
Set Trusted
Host
Enter the textual identification of the contact person for this the device, for
example, contact or e-mail address.
Enter a name for the device.
Enter the location of the device. For example, the name can be composed of the
building, floor number, and room location.
Specify the community that has read-only access to the device's SNMP
information.
Enter the IP address that can serve as Get Community to read the SNMP
information of this device.
Specify the community who has the read and write right of the device's SNMP
information.
Enter the IP address that can serve as Set Community to read and write the SNMP
information of this device.
SNMP
Configuration Guide 162