JRC JCY-1800 Instruction Manual page 48

4. Installation, Setup and Check
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
2) Enable setting
Setup procedure is the same as "Engine telegraph position".
3) Disable setting
Select the "Other".
4.5.5.5.5. Order or Response (Status)
Select the sentence type (Order / Response) of engine telegraph signals.
4.5.5.5.6. Engine, Propeller position
Select the position of an engine and a propeller shaft.
• Single or on center line
• Port
• Starboard
4.5.5.5.7. Registration of Engine telegraph sentence data
The NMEA sentence for engine telegraph is registered.
1) ETL sentence identification number
Select the identification number in the case of registering two or more ETL sentences.
When registering only one sentence, it is necessary to select as "01" by a default, but in registering two or more, set
up an increment number. It can set up from "01" to "04."
2) Registering sentence data
Click the [SET] button.
An ETL sentence is registered.
DOC No. 7ZPNA4014
42