JRC JCY-1800 Instruction Manual page 33

4.4.3. Detail setup window of Heading data (CH33）
4.4.3.1. Identification TAB screen
Set an identification data of connected equipment which output a Synchro signal or a step signal as heading data.
1) Equipment
Enter the name of the connecting equipment. (Gyro, etc.)
2) Model
Enter the model name of the connecting equipment.
3) Manufacturer
Enter the name of the manufacturer of the connecting equipment.
4) Serial No.
Enter the serial number of the connecting equipment.
* The old equipment by which the serial number is not displayed also exists. In that case, enter "unknown" into
the Serial No. column.
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
27
4. Installation, Setup and Check
DOC No. 7ZPNA4014