Konica Minolta BIZHUB 367 Installation Manual page 4

(2) Remove the locking materials.
Note:
Keep the locking materials. It is necessary for
transporting the machine.
a) Open the right door and remove the locking
materials.
Note:
After removing the locking materials, make sure
that the transfer roller assy is secured in place. In
the case of <NG>, press the transfer roller assy
into place so that it is secured as shown in <OK>.
< OK >
b) Close the right door.
c) Remove the locking material at the left side of
the scanner unit.
(3) Affix the supplied blind label.
(4) Slide out the tray 1.
(5) Remove the protective tape from the inside of
< NG >
(6) Slide out the tray 2.
(7) Remove the protective tape from the inside of
E-4
the tray 1.
the tray 2 and remove accessory parts.