Table of Contents
Advertisement
TL-WA7510N
¾
RTS Threshold - Here you can specify the RTS (Request to Send) Threshold. If the packet is
larger than the specified RTS Threshold size, the Device will send RTS frames to a particular
receiving station and negotiate the sending of a data frame. The default value is 2346.
¾
Fragmentation Threshold - This value is the maximum size determining whether packets
will be fragmented. Setting the Fragmentation Threshold too low may result in poor network
performance since excessive packets. 2346 is the default setting and is recommended.
¾
DTIM Interval - This value determines the interval of the Delivery Traffic Indication Message
(DTIM). You can specify the value between 1-255 Beacon Intervals. The default value is 1,
which indicates the DTIM Interval is the same as Beacon Interval.
¾
Enable WMM - WMM function can guarantee the packets with high-priority messages being
transmitted preferentially. It is strongly recommended enabled.
¾
Enable Short GI - This function is recommended for it will increase the data capacity by
reducing the guard interval time.
¾
Enable AP Isolation - Isolate all connected wireless stations so that wireless stations cannot
access each other through WLAN. This function will be disabled if WDS/Bridge is enabled.
)
Note:
If you are not familiar with the setting items in this page, it's strongly recommended to keep the
provided default values; otherwise, it may result in lower wireless network performance.
5.7.5 Antenna Alignment
)
Note:
This function is not available in AP Router mode, but in both Standard AP mode and AP Client
Router mode.
Choose menu "Wireless > Antenna Alignment", and then you can know how remote the
Device's signal strength changes while changing the antenna's direction.
5GHz 150Mbps Indoor/ Outdoor Wireless Access Point User Guide
Figure 5-35 Antenna Alignment
108
Advertisement
Table of Contents
