Manual Initialization Of Linear Actuators; Preparing Part-Turn Actuators For Commissioning - Siemens SIPART PS2 6DR5 series Operating Instructions Manual

7. The following display indicates that the automatic initialization is complete:
Aborting the automatic initialization process
1. Press the button. The display shows the following:
The positioner is in the "Configuration" mode.
2. Exit the "Configuration" mode. To do this, press the
The software status is displayed.
After releasing the
5.6.3

Manual initialization of linear actuators

See detailed operating instructions for information on manual initialization of linear actuators.
5.7 Commissioning part-turn actuators
5.7.1

Preparing part-turn actuators for commissioning

Note
Setting of the adjustment angle
The usual adjustment angle for part-turn actuators is 90°.
● Set the transmission ratio selector in the positioner to 90°.
Condition
The following conditions must be fulfilled before activating the initialization:
1. You have installed the positioner for the part-turn actuators using the suitable mounting kit.
2. You have connected the actuator and the positioner to the pneumatic lines.
3. Pneumatic auxiliary power is supplied to the positioner.
4. The positioner has been connected to a suitable current or voltage source.
Setting the actuator
1. The positioner is in the "P manual mode". The current potentiometer voltage P in percent is shown on the upper line in
the display. "NOINI" blinks in the lower line of the display. Examples of corresponding displays are given below:
2. Check whether the mechanical unit can be moved freely in the entire actuating range. Move the drive to the respective
end position for this purpose using the
30
button, the positioner is in "P manual mode". The positioner is not initialized.
or
button for at least 5 seconds.
button.
SIPART PS2 (6DR5...)
A5E03436655-02, 01/2013