Reading Other Wireless Connection Variables - Intermec EasyCoder PF2i Installation Instructions Manual

An additional item is "STATE", which is read-only for all users:
SETUP GET "8021x","STATE",A$
Gets the supplicant state: "Disabled", "Failed", "Authenticating", or
"Authenticated".
Note: If you start the printer with EAP type set to OFF and
then change the EAP type to TTLS, LEAP, or PEAP, you need
to reboot the printer for your new settings to take eff ect. Until
you reboot, STATE returns "Disabled."
802.1x supplicant state, EAP type, outer name, inner authentication,
installed root certifi cate, server common names, and server certifi cate
validation can be seen on the printer's web page and the network test
label.

Reading Other Wireless Connection Variables

In addition to SSID, WEP, WLAN, and 802.1x settings, the following
information can be read using SETUP GET instructions:
• Active channel
• MAC address of the access point
• Signal strength
1
• Speed
2
• Region
1
/. Th e information is also given on the network test label and on the
web page.
2
/. Th e current region is also presented on the web page.
3
/. Active channel and signal strength is shown in the printer's display
window when the <i> key is pressed.
EasyLAN Wireless Interface Kit Installation Instructions
1,3
1,3
Chapter 4 — Setup in Fingerprint
1
37