Table of Contents
Advertisement
Installation
Inserting batteries into the
remote control
Insert two batteries type R03 or AAA into the
remote control with the correct polarity as
indicated by the "+" and "-" symbols inside
the battery compartment.
1
3
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed off properly.
12
2
Setting the clock
The time is displayed using the 12-hour clock.
1
Check the system is switched to standby mode.
(see Basic Functions, Switch on/to standby)
AM 12: 00 flashes by default if the clock is
not set.
2
On the system, press and hold PROGRAM for
more than 2 seconds.
The hour digit starts flashing.
3
Hold down or press 4 or ¢ repeatedly to
set the hour. Release 4 or ¢ when you
have reached the correct setting.
4
Press PROGRAM to confirm the setting.
The minute digit starts flashing.
5
Repeat step 3 to set the minute.
6
Press PROGRAM to confirm the setting.
The clock shows the set time.
Helpful hints:
– You may lose your clock setting when the power
cord is disconnected or power failure occurs.
Advertisement
Table of Contents
