Table of Contents
Advertisement
FM antenna
1
Extend the wire antenna and move the antenna
in different positions for optimal reception (as far
away as possible from the TV, VCR or other
radiation sources).
2
Fix the antenna's end to the wall.
C
Connecting an additional appliance
It is possible to use an additional appliance, e.g.
TV, VCR, Laser Disc player, DVD player or CD
recorder, with the system.
1
Insert the red plug of the red/white audio cables
(not supplied) to the red socket AUX IN R and
the white plug to the white socket AUX IN L.
2
Connect the other end of the audio cables to
the AUDIO OUT terminals of the additional
appliance.
Helpful hints:
– If the connected device has only a single audio
out terminal, connect it to the AUX IN left
terminal. Alternatively, you can use a "single to
double" cinch cable, but the output sound still
remain mono.
– Always refer to the owner's manual of other
equipment for complete connection.
Using AC power (illustration on Page
10)
1
If your system is equipped with
a VOLTAGE SELECTOR, set
this selector to your local
power voltage if necessary.
2
Make sure all connections have
been made before switching on
the power supply.
3
Connect the power cable supplied to
AC MAINS ~ and to the wall socket. This
switches on the power supply.
When the system is switched to standby, it is still
consuming some power. To disconnect the
system from the power supply completely,
remove the power plug from the wall
socket.
The type plate is located on the rear of the
set.
Installation
11
Advertisement
Table of Contents
