Table of Contents
Advertisement
Preparing the remote control
IMPORTANT:The remote control will work within a 6m range; however, this may be
impossible if there are obstacles between the unit and the control.
If the remote control is used near other devices which generate infrared rays then it
may not operate properly and may interfere with other devices.
For first time use:
The unit has a pre-installed lithium CR2025
battery(included)Remove the protective tab to
activate the remote control battery.
To replace the remote control battery:
1.
Push the switch at the side of the battery
tray towards the tray (A).
2.
Now slide the battery tray out of the
remote control (B).
3.
Remove the old battery.
4.
Place a new CR2025 battery into the battery
tray with the correct polarity (+/-) as
indicated.
5.
Slide the battery tray back into the slot in
the remote control.
Important battery information:
When the remote control is not used for a long time (more than a month),
•
remove the battery to prevent it from leaking.
If the batteries do leak, wipe away the leakage inside the battery compartment
•
and replace the batteries with new ones.
Do not use any batteries other than those specified.
•
Do not heat or disassemble batteries. Never throw them in fire or water.
•
Do not carry or store batteries with other metallic objects. Doing so could
•
cause batteries to short circuit, leak or explode.
Never recharge a battery unless it is a rechargeable type.
•
5
Advertisement
Table of Contents
