Liquid Phase Simulate - Hach BioTector B7000 User Manual

Liquid Phase Simulate

L I Q U I D P H A S E
N I T R O G E N :
S / R R A T I O
S = 6 2 5 0 0 0
R = 3 4 4 0 0 0
1 L I Q U I D
2 X E N O N
3 N P S A M P L E
1 0 D I W A T E R
1 1 T N C L E A N I N G
1 2 N P U M P
1 8 D C P L E A K
1 9
▼
L I Q U I D P H A S E

2 0 O X I D A T I O N
2 1 C L E A N I N G
2 2 S A M P L E
2 3
2 4 - - > I N P U T / O U T P U T
The Liquid Phase Simulate menu enables the user to test Liquid Phase system components and also the
relevant Oxidation Phase system components such as pumps, valves, lamp, boilers etc. installed in
BioTector. The menu also shows the current status of all devices when the BioTector is running. Note that the
Liquid Simulate screen may change slightly depending on system settings. Any settings made by the user in
this menu are automatically reset when the user exits this menu.
Each time a component is activated, the BioTector will interlock additional devices to
ensure that the component being tested can be checked in a manner that will not
cause consequential damage to the overall system. It is recommended that each
test is evaluated carefully, for although the interlocks are extensive, it may still be
possible to damage the system.
S I M
= 1 . 8 1 7
P H A S E C O M P O N E N T S
L A M P
V A L V E
V A L V E
V A L V E
D E T E C T O R
S I M
P H A S E C O M P O N E N T S
V A L V E
P U M P
S T A T U S
0 9 : 1 7 : 2 8 1 2 - 0 9 - 0 2
O F F
O F F
O F F
O F F
O F F ,
O F F 1 8
0 9 : 1 7 : 2 8 1 2 - 0 9 - 0 2
O F F
O F F ,
1
1
Page 93