Processor; Removing The Processor - HP CL2100 G3 807S User And Maintenance Manual

Repeat the procedure for the additional heat sink.
7.
Install the access panel (on page 38).
8.

Processor

Removing the processor

CAUTION:
Processor0 socket (see page 13 for location).
ESD protection must be worn during the procedure to avoid damaging the components.
To remove the processor:
Power down the server and detach all of the power cords from the power supplies.
1.
Remove the access panel (on page 37).
2.
Remove the heat sink (on page 29).
3.
Press downward and inward on the right processor locking lever to release it.
4.
Press downward and inward on the left processor locking lever, pulling it fully open.
5.
Lift the processor load plate to the fully open position.
6.
In a single processor configuration, the single processor must be installed in the
Installation 31