Processor Problems - HP CL2100 G3 807S User And Maintenance Manual

Unsupported DIMM in Socket X
o
Possible cause: Unregistered DIMMs or insufficient DIMM timings.
Action: Install registered ECC DIMMs.
Memory configuration warning
4.
The DIMM in socket X does not have a primary width of 4 and only supports standard ECC.
Advanced ECC does not function when mixing DIMMs with primary widths of x4 and x8.
Possible cause: The installed DIMMs have a primary width of x8.
Action: Install DIMMs that have a primary width of x4 if advanced ECC memory support is required.
DIMM initialization error
5.
Receive enable error. Cannot train memory.
Possible cause: The system receives a receive enable error during memory training.
Action: Contact JV support.
DIMM configuration error
6.
Quad Rank DIMMs must be installed in the first socket of any memory channel in which they are
o
populated. System stopped
Possible cause: Quad rank DIMMs are installed after SR or DR DIMMs.
Action: Be sure that quad rank DIMMs are installed in the first socket of any memory channel.
UDIMMs and RDIMMs are installed in the system. The system cannot have both types of DIMMs
o
installed. System stopped
Possible cause: A DIMM configuration error exists with mismatched DIMMs.
Action: Be sure all DIMMs are of the same type.
Invalid Lockstep memory configuration
7.
Possible cause: The memory is not installed properly to support Lockstep mode.
Action: Install or reinstall DIMMs to support mirrored mode.
Mirror memory configuration
8.
Memory sizes on boards X and Y do not match
o
Possible cause: The overall size of two boards that are participating in a mirrored configuration
does not match.
Action: Install or reinstall the DIMMs to support mirrored mode.
Non-numeric messages or beeps only
9.
Advanced memory protection mode: Advanced ECC
o
Possible cause: Advanced ECC support is enabled.
Action: None.
Advanced memory protection mode: Advanced ECC with hot-add support
o
Possible cause: Advanced ECC with hot-add support is enabled.
Action: None

Processor problems


Be sure that the server supports each processor and that each processor is correctly installed.
Diagnostic flowcharts 85