Epm Logging - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 49 Configuring 802.1X Port-Based Authentication
Switch# show mab all detail
MAB details for FastEthernet5/9
-------------------------------------
Mac-Auth-Bypass
Inactivity Timeout
MAB Client List
---------------
Client MAC
MAB SM state
Auth Status
Switch# show mab int fa5/9
MAB details for FastEthernet5/9
-------------------------------------
Mac-Auth-Bypass
Inactivity Timeout
Switch# show mab int fa5/9 detail
MAB details for FastEthernet5/9
-------------------------------------
Mac-Auth-Bypass
Inactivity Timeout
MAB Client List
---------------
Client MAC
MAB SM state
Auth Status

EPM Logging

EPM logging enables you to display EPM logging messages by using the epm logging command in global configuration mode.
To disable EPM logging, enter no epm logging.
Logging messages are displayed during the following events:
POLICY_APP_SUCCESS—Policy application success events on Named ACLs, Proxy ACLs, and service policies, URL
•
redirect policies.
• POLICY_APP_FAILURE—Policy application failure conditions similar to unconfigured policies, wrong policies,
download request failures and download failures from AAA.
• IPEVENT—IP assignment, IP release and IP wait events for clients.
• AAA—AAA events (similar to download requests, or download successes from AAA)
Example 1
Switch# conf t
Enter configuration commands, one per line.
Switch(config)# epm logging
Switch# clear dot1x all
Switch#
*May 15 08:31:26.561: %EPM-6-POLICY_REQ: IP=100.0.0.222| MAC=0000.0000.0001|
AUDITSESID=0A050B2C000000030004956C| AUTHTYPE=DOT1X|
EVENT=REMOVE
*May 15 08:31:26.581: %AUTHMGR-5-START: Starting 'dot1x' for client (0000.0000.0001) on Interface Fa9/25
*May 15 08:31:26.681: %DOT1X-5-SUCCESS: Authentication successful for client (0000.0000.0001) on Interface
Fa9/25
*May 15 08:31:26.681: %AUTHMGR-7-RESULT: Authentication result 'success' from 'dot1x' for client
(0000.0000.0001) on Interface Fa9/25
= Enabled
= None
= 000f.23c4.a401
= TERMINATE
= AUTHORIZED
= Enabled
= None
= Enabled
= None
= 000f.23c4.a401
= TERMINATE
= AUTHORIZED
End with CNTL/Z.
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Displaying Authentication Details
49-127