Denso BHT-805BW Operator's Manual page 45

Message BHT Response
Your terminal was The
not shut down continues to display.
properly the last
time it was used.
Unsaved data
was lost.
Reload the battery If this error occurs, the
to restart! warning tone beeps
five times.
XXXXXXXX 01
Reload the battery If this error occurs, the
to restart! warning tone beeps
five times.
tskid : XXXXXXXX
ercd : XXXXXXXX
addr : XXXXXXXX
No user programs The
found. continues to display.
Run code scanning
demo?
1:Yes 2:No
Contact your If this error occurs, the
administrator. warning tone beeps
five times and then
Note the error
turns itself off.
number.
( XXXX )
No resume info. The BHT displays this
has been retained. error message
automatically runs the
Program restarts
execution
automatically.
from
start-up.
Problem
message After being shut down
abnormally, the BHT
has been left without
the battery cartridge
loaded,
discharged
cartridge loaded, so
unsaved data
lost.
During execution of
System Program, the
System Program has
attempted
onto the
protected area of the
memory.
(xxxxxxxx:
Error address)
During execution of
System Program, the
System Program has
received an
command code.
(xxxxxxxx:
Error address)
message When the
turned on, no user
programs are found.
A hardware
memory
execution
error, etc.
occurred.
(xxxx: Error code)
Operation
and terminated
turning OFF the power
program normally
the point of resume function set,
and therefore resume
info has been lost.
31
Troubleshooting Guide
Solution
Contact your system
administrator.
or with
battery
was
to write
Unload and reload the
write-
battery cartridge, then
turn the BHT on.
If this error occurs
frequently, make
note of the displayed
message and codes
and contact
system administrator.
invalid
BHT is Contact your system
administrator.
You can run the code
scanning
without
programs.
Pressing "1:Yes" runs
the code scanning
demo.
Press the
switch to start the
code scanning demo.
Selecting "2:No" turns
the power off.
error,
Turn the BHT
error,
again.
program
If this error occurs
has
frequently, make
note of the displayed
code and contact your
system administrator.
was If this error occurs
without frequently, make
note of the displayed
with the code and contact your
system administrator.
a
your
demo
user
trigger
on
a
a