Wireless Equipment - Denso BHT-805BW Operator's Manual

Wireless Equipment

Precautions relating to the frequency used by this device
In addition to industrial, scientific, and medical equipment such as microwave ovens,
static wireless stations (permit required) used for mobile identification in places
such as plant manufacturing lines and specified low-power wireless stations (no
permit required) operate on the same frequency band as this device.
1. Before using this device, ensure that no static wireless stations or specified
low-power wireless stations for mobile identification are being used in the vicinity.
2. In the event of instances of electromagnetic interference from this device to a
static wireless station being used for mobile identification, either promptly alter the
usage frequency, or halt the electromagnetic discharge
3. If other problems arise due to reasons such as electromagnetic interference from
this device to a specified low-power wireless station being used for mobile
identification, please contact DENSO WAVE through QBdirect (see page iv).
Requests to system designers
Communication may not be possible depending on the environment in which the
device is being used. Ensure that problem-free communication is possible prior to
use.
Use a program capable of retransmitting data if communication fails.
If the BHT is introduced into an environment in which a device using the 2.4GHz
frequency band is operating, or if a another device using the 2.4GHz frequency
band is introduced following introduction of the system, run all devices and
ensure that communication with the BHT is possible prior to use.
Check communication once again prior to use if any changes are made to the
usage environment (addition of household appliances, movement or addition of
shelves, equipment and so on) following introduction of the system.
2