Advertisement
If a problem should develop while operating the CD changer, the following error codes
may appear on the display panel.
ER-1: Indicates that there is no magazine loaded in the CD changer.
ER-2: Indicates a problem with the magazine eject function.
ER-3: Indicates an error in the disc loading function.
ER-4: Indicates an error in the disc un-loading function.
ER-5: Indicates an error in the magazine position.
ER-6: Indicates an error in the laser pick-up position.
ER-7: Indicates an error in the laser focus on the disc.
In any of the above situations, try ejecting the CD magazine from the changer and make
sure the discs are clean, undamaged, and loaded correctly (refer to the Owner's Manual
of the CD changer). Re-load the magazine and check for proper operation. You may
also try activating the RESET button
pre-set memories.
If the suggested measures do not solve the problem, contact an approved warranty station
near you for further assistance.
WIRELESS REMOTE
CONTROL OPERATION
The wireless remote control supplied with
this model is capable of operating most
of the features of the unit from a remote
location. Each button on the remote
control functions in the same way as the
referenced button on the main unit. For
optimal operation of the remote control,
always aim it toward the Remote Sen-
do
sor
on the front panel of the main unit.
1 1 1 1 1
POWER ON/OFF - See Main Unit
1
.
2 2 2 2 2
MODE SELECTOR (MODE/7) -
See Main Unit
3 3 3 3 3
INFRARED SENDER - Emits infra-
16 16 16 16 16
red signal to radio which is detected
by the sensor
CD CH
CD CHA A A A A NGER ERR
CD CH
NGER ERR
NGER ERR
CD CH
CD CH
NGER ERR
NGER ERROR CODES
dm
on the unit, but this will also erase the time and
bt
dp
and
.
do
.
OR CODES
OR CODES
OR CODES
OR CODES
4 4 4 4 4
VOLUME (LEVEL) CONTROL- See Main
2
3 4
5
Unit
,
,
press
to increase level, and press
to decrease level.
5 5 5 5 5
SELECT BUTTON (SEL) - See Main Unit
3
4
5
6
,
,
,
, and
6 6 6 6 6
TUNE/SEEK (9,8) CONTROL – See
bm
Main
Unit
to increase frequency, and press
to decrease frequency.
MANUAL SEEK TUNING – See Main
bm
Unit
,except press
upward, press
CD TRACK SELECT – See Main Unit
c l
d r
a n d
to select a higher track number,
press
to select a lower track num-
ber.
6
7
,
, and
except
7
.
except
press
to Seek
to Seek downward.
e x c e p t
press
Advertisement
