Advertisement
accidentally damaged (
display panel to indicate that a disc is
loaded in the player). Play of the disc can
be resumed by using the MODE button
to choose the CD player function.
ct ct ct ct ct
TIME/FREQUENCY SELECTOR (T/F)
During radio operation, press this button to
call the time display on the incorporated
quartz clock. The current time will appear
together with an A or P indication. The
display will return to the radio frequency
indication after 5 seconds.
During disc play press of this button to call
the time display. The display will return to
the disc indication after 5 seconds.
cu cu cu cu cu
EQUALIZER BUTTON (P.EQ)
The P.EQ button applies preset sound effects
to the unit's audio output signal.The P.EQ
button, when pressed, will activate one of
the following operating modes (CLASSICS,
POP M, JAZZ, DSP OFF or FLAT). Even
though the Equalizer function is active, as
displayed on the panel, if the bass and/or
treble level is set, the Equalizer function
automatically returns to the FLAT mode.
Conversely, when the Equalizer function is
not active, the unit returns to the user set
bass and treble levels.
dl dl dl dl dl
THEFT-DETERRENT LED
Located on the chassis behind the front
panel, a light-emitting diode (LED) will flash
when the panel is physically removed. The
flashing light serves as a visual warning to
the would-be thief that the unit has been
disabled by removal of the front panel.
dm dm dm dm dm
RESET BUTTON
The RESET button is located to the right of
the theft deterrent LED. The reset circuitry
should only be activated under the following
will appear on the
circumstances as it will erase the time
and pre-set memories:
1.Upon initial installation after all wiring is
bt
completed.
2.If there is a malfunction of any of the
switches on the unit, pressing the RESET
button may clear the system and return
to normal operation.
dn dn dn dn dn
This button is used to release the
mechanism that holds the front panel to the
chassis. To detach the front panel, press
the button so that the panel drops to the
lowered position. Grasp the panel at the
middle, press the RELEASE bar, and pull it
off of the chassis. To re-attach the panel,
press it straight onto the chassis until the
mechanism locks it into place.
do do do do do
The sensor to detect the infrared signal from
the wireless remote control is located behind
the VFD display lens. For optimum operation
of the remote control, always aim the control
at the VFD display.
NOTES ON USE OF FRONT PANEL:
1.Make sure the front panel is positioned
correctly when attaching it to the chassis
as it cannot be attached when up-side
down. Use moderate pressure to fully
seat the panel into position.
2.To verify correct panel installation, swing
the panel assembly up into position until
it locks easily into place. If any resistance
is
orientation in chassis mounting plate.
FRONT PANEL RELEASE BUTTON
(OPEN)
REMOTE SENSOR
encountered,
re-check
panel
11 11 11 11 11
Advertisement
