Furuno FR-8062 Operator's Manual page 96

3. Use the trackball to choose Test and then press the ENTER key.
ROM
RAM
NMEA1
NMEA2
RS-232C
PROGRAM NUMBER
HEADING
BEARING
TUNE VOLTAGE
INDICATOR VOLTAGE
ANTENNA ROTATION
MOTOR VOLTAGE
ECHO LEVEL
TRIGGER FREQUENCY
TOTAL ON TIME
TOTAL TX TIME
Input NMEA data sentences appear here.
ARP-11 PROGRAM NUMBER: 035-1515-XX.XX
ARP-11
[MENU] x 3 : Exit
• At the top of the screen the results of system checks are displayed. OK or NG (No Good)
is shown as the result for the check of ROM, RAM, data ports NMEA1 and NMEA2
(blank if no data is input) and RS-232C. For any NG contact your dealer for advice.
PROGRAM NUMBER shows program number and program version number.
• Heading and bearing signals are checked for proper input and the result displayed as
OK or NG. Tune and indicator voltages, antenna rotation speed, antenna motor voltage,
echo level and trigger frequency are measured and shown. TOTAL ON TIME and
TOTAL TX TIME show the total number of hours the radar has been powered and trans-
mitted, respectively.
• The INPUT NMEA window shows all the NMEA sentences being input to this radar.
• If the optional ARP-11 is connected, its program number and test results are shown
below the INPUT NMEA window.
: OK
: OK
: OK
: OK
: OK
: 0317101-XX.XX
: OK
: OK
: 10.1 V
: 4.2 V
: 48.1 rmp
: 23.4 V
: -40 dBm
: 3000 Hz
: 123456.7 H
: 987654.3 H
INPUT NMEA
: OK
DIagnostics screen
6. MAINTENANCE & TROUBLESHOOTING
000
000
000
000
000
<REMOTE CONTROLLER>
6-9