Sart (Search And Rescue Transponder) - Furuno FR-8062 Operator's Manual

2.3

SART (Search and Rescue Transponder)

2.3.1 SART description
A Search and Rescue Transponder (SART) may be triggered by any X-Band (3 cm) radar within
a range of approximately 8 nm. Each radar pulse received causes it to transmit a response which
is swept repetitively across the complete radar frequency band. When interrogated, it first sweeps
rapidly (0.4 µs) through the band before beginning a relatively slow sweep (7.5 µs) through the
band back to the starting frequency. This process is repeated for a total of twelve complete cycles.
At some point in each sweep, the SART frequency will match that of the interrogating radar and
be within the pass band of the radar receiver. If the SART is within range, the frequency match
during each of the 12 slow sweeps will produce a response on the radar display, thus a line of 12
dots equally spaced by about 0.64 nautical miles will be shown.
When the radar to the SART is reduced to about 1 nm, the radar display my show also the 12
responses generated during the fast sweeps. These additional dot responses, which also are
equally spaced by 0.64 nautical miles, will be interspersed with the original line of 12 dots. They
will appear slightly weaker and smaller than the original dots.
Position of
SART
Screen A: When SART
is distant
Echo from SART Radar antenna
beamwidth
24 NM
Own ship
position
SART mark
length
9500 MHz
9200 MHz
7.5 µs
Low speed sweep signal
Sweep start
High speed sweep signal
Appearance of SART echo
Screen B: When SART
is close
Lines of 12 dots
are displayed in
concentric arcs.
1.5 NM
Own ship
position
Radar receiver
bandwidth
Sweep time
95 µs
2. RADAR OBSERVATION
Echo from
SART
Position of
SART
2-5