TP-Link EAP110 User Manual page 75

To configure the EAP as an SNMP agent, go to the Management > SNMP page.
Follow the steps below to complete the configuration on this page:
1. Check the box to enable SNMP Agent.
2. Refer to the following table to configure the required parameters:
SysContact
SysName
SysLocation
Get Community
Get Source
Set Community
Enter the textual identification of the contact person for this managed
node.
Enter an administratively-assigned name for this managed node.
Enter the physical location of this managed node.
Community refers to a host group aiming at network management.
Get Community only has the read-only right of the device's SNMP
information. The community name can be considered a group password.
The default setting is public.
Defines the IP address (for example, 10.10.10.1) for management
systems that can serve as Get Community to read the SNMP information
of this device. The default is 0.0.0.0, which means all hosts can read the
SNMP information of this device.
Set Community has the read and write right of the device's SNMP
information. Enter the community name that allows read/write access to
the device's SNMP information. The community name can be considered
a group password. The default setting is private.
71