Configure Trunk (For Eap330) - TP-Link EAP110 User Manual

To configure Management Access, go to the Management > Management Access page.
Follow the steps below to configure Management Access on this page:
1. Check the box to enable MAC Authentication.
2. Specify one or more MAC addresses in the MAC1/MAC2/MAC3/MAC4 fields. Up to
four MAC addresses can be added.
3. Click Save.


iipe
You can click
·
Verify the MAC addresses carefully. Once the settings are saved, only the hosts in the MAC
·
address list can access the web page of the EAP.
If you cannot log in to the web page after saving the wrong configuration, you can reset the EAP
·
to the factory defaults and use the default username and password (both admin) to log in.

4.4 Configure Trunk (For EAP330)

The trunk function can bundle multiple Ethernet links into a logical link to increase
bandwidth and improve network reliability. The EAP330 has two 1000Mbps Ethernet ports.
If the Trunk function is enabled and the ports are in the speed of 1000Mbps Full Duplex,
the whole bandwidth of the trunk link is up to 4Gbps (2000Mbps * 2).

Ntte

The trunk feature here refers to static trunk. Make sure that the trunk mode of the peer is static.
to quickly add the MAC address of your current logged-in host, .
67