Precaution; Specific Service Instructions; System Set-Up; Realignment - Kenwood TK-D240 Service Manual

This service manual does not describe PRECAUTION.
2.1

SYSTEM SET-UP

Merchandise received
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
Are you using the speaker microphone?
2.2

REALIGNMENT

2.2.1 Modes
User mode
PC mode
Firmware programming mode
Mode
User mode For normal use.
PC mode Used to communication between the
transceiver and PC.
PC programming Used to read and write frequency data and
mode other features to and from the transceiver.
PC test mode Used to check the transceiver using the
PC. This feature is included in the FPU.
SECTION 1

PRECAUTION

SECTION 2

SPECIFIC SERVICE INSTRUCTIONS

A personal computer, programming interface (KPG-22A/22U),
and FPU (programming software) are required for programming.
(The frequency, TX power HI/LOW, and signaling data are
programmed for the transceiver.)
YES
NO
YES
NO
Delivery
Data programming mode
PC tuning mode
PC test mode
Function
Frequency range (MHz) RF power
136~174 5.0W
KRA-22, KRA-26 or KRA-41
Optional antenna
KMC-21, KMC-45D
Speaker microphone
(Option)
Mode
PC tuning mode Used to tune the transceiver using the PC.
Firmware program- Used when changing the main program of
ming mode the flash memory.
2.2.2 How to Enter Each Mode
Mode
User mode Power ON
PC mode Received commands from PC
Firmware pro- [Side2] + Power ON (Two seconds)
gramming mode
Type
TK-D240 K,M,E,E2
TK-D240(V) K
Function
Operation
(No.RA035<Rev.001>)1-5