Precaution; Specific Service Instructions - Kenwood NX-5600HB Service Manual

This service manual does not describe PRECAUTION.
2.1 SYSTEM SET-UP
Merchandise received
Select the type of transceiver
NX-5600HB is complete by combining options with
only the transceiver body (without panel).
Are you using the Multi-RF Deck/Multi-Control
Head remote kit?
NO
Are you using the ignition sense cable?
NO
KCT-23 DC cable
Are you using the GPS function?
NO
Are you using the external speaker?
NO
Are you using the public address?
NO
Are you using the microphone?
NO
Are you using the secure cryptographic module?
NO
Transceiver programming
Delivery
1-4 (No.RA075<Rev.001>)
SECTION 1

PRECAUTION

SECTION 2

SPECIFIC SERVICE INSTRUCTIONS

NX-5600HB F3
RF Deck (NX-5600HB) is possible to combine and install the Remote Kit
(KRK-14H), Control Head (KCH-19, KCH-20R, KCH-21R) and Cable
(KCT-71, KCT-72) respectively.
YES
Refer to the KRK-14H/15B service manual (B5B-7173-20) for Setup and
installation information for all combinations.
Note: The function of the KRK-15B is incorporated in the NX-5600HB.
YES
KCT-23 M2,M4
YES
YES
YES
KMC-27A,KMC-27B,KMC-28A,
YES
KMC-35,KMC-36,KMC-65,KMC-66
YES
A personal computer, programming interface (KPG-46U/46X),
and FPU (programming software) are required for programming.
Type Frequency range (MHz)
TX/RX 39~50
KCT-18
(Option)
KRA-40 GPS active antenna
(Option)
KES-5 or KES-5A
(Option)
KES-5 or KES-5A
(Option)
(Option)
Desk top microphone KMC-9C
KWD-AE30 or KWD-AE31
(Option)
RF power Operation panel
110W No
Refer to the "2.3.2 Ignition Sense
Cable (KCT-18: Option)".
Refer to the "2.3.3 External Speaker
(KES-5/KES-5A: Option)".
Refer to the "2.3.3.3 Use as public
address speaker".
Refer to the "2.3.5 SECURE
CRYPTOGRAPHIC MODULE
(KWD-AE30/KWD-AE31: Option)".