Table of Contents
Advertisement
Replacement
1.
Fold the new cable on the mark
Da.
2.
Attach the cable clamp assembly and cable to the
bracket
III.
3.
Make a 90° counterclockwise twist in the cable
and fold the cable at right angles to the long part
of the cable.
4.
5.
Place the 2 small parts of the cable in the bracket
notch
II
and fold them back.
Push the large connector through the hole in the
casting and fasten the cable clamp bracket in
place (2 screws)
II.
6.
Work the cable into the holes so that the locking
arms
IE
are at the left.
7.
Place the 2 small cables under the clamp for the
print emitter pickup and install the screws loosely.
8.
Form the cable to the flat spring.
9.
Form a loop in the cable
II
at the end of the flat
spring.
10.
Form the print head cable around the head
mounting pin
II
before connecting the cable to
EC3. The loop must be large enough here so the
cable causes no interference with print head
movement.
11.
Install the print head (160).
12.
Install the printer on the power supply (115).
13.
Connect P2A and P28
D.
14.
Adjust the print emitter to the pickup (140).
15.
Adjust the left margin (143).
162
Remove, Replace,
Adjust
Maintenance
- l
I
,
5256 MIM
1-47
Advertisement
Table of Contents
