IBM 5256-1 Maintenance Information Manual page 166

When the following setup procedure refers you to the
problem
determinati~n
procedures or to a service
representative, go to the
Start
of Call instead.
Your 5256 Printer is shipped to you fully tested and
adjusted. This setup and checkout procedure should be
used after your printer is unpacked and placed where
you intend to use it, or whenever a printer is
disconnected and relocated.
Appendix A .. Setting up the IBM 5256 Printer
CAUTION
The 5256 Printer weighs approximately 35 kilograms (78
pounds). NEVER LIFT IT BY YOURSELF.
This setup procedure is written in two sections:
• The steps in Section 1 can be completed without
connecting your printer to the system. The steps
explain how to set up the forms feeding equipment,
how to use printer controls, and how to do a print
test.
• The steps in Section 2 explain how to connect the
printer to the system and how to use a checkout
procedure to make sure the printer and system are
communic~ting properly ..
You should inspect the printer for any transit damage.
Any damage discovered should be promptly reported to
the local IBM branch office.
Appendix 5256 MIM A-1
Appendix,
Index