IBM 5256-1 Maintenance Information Manual page 171

d. When the Ready light goes off, press the Start
switch again to start printing. The Ready light
will come on and remain on while the 5256 is
printing.
1 2
• Power
On
• Ready
OLlne
Sync
OSVSlem
AvaIlable
Lone Form
Pow~, SlOP Slarl
Feed
Feed
~on
Off
B B B B
The printout should look like this':
A-6
---------¢.«+I&---------!S*);~-I--------:,%_)7---------' :~@'="-abcdefghi-------jkLffinoP'r-----I--stuvwxyZ--·
(ABCDEFGHI------)JKLHNOPQR------\-STUVWXYZ------0123456789------
---------¢. ( (+ I &---------! $*) ;
~-/~-------:
,%_ )7---------' :
~@
I = "-abcdefgh i ------- j k LlllnoP't.r-----I--st uvwxyz--
(ABCDEFGHI------)JKLHNOPQR--·----\-STUVWXYZ------0123456789------
---------¢.«+I&---------!S*);~-I--------:,%_)7---------' :~@'="-abcdefghi-------jkLffinoP'r-----I--stuvwxyZ--·
(ABCDEFGHI------)JKLHNOPQR------\-STUVWXYZ------0123456789------
---------¢.«+I&---------!S*);~-I--------: ,%_)?---------':~@I="-abcdef9hi-------jkLffinoP'r-----.--stuvwxyz--'
(ABCDEFGHI------}JKLHNOPQR------\-STUVWXYZ------0123456789------
---------¢.«+I&---------!S~);~-/--------:,X_>7---------':~@I="-abcdefghi-------jkLffinoP'r-----I--stuvwXyZ-­
(ABCDEFGHI------}JKLMNOPQR------\-STUVWXYZ------0123456789------
---------¢.«+I&---------!$*);~-I--------:,X_}?------- --' :~@I="-abcdefghi-------jkLffinoP'r-----I--stuvwxyZ--·
(ABCDEFGHI------}JKLHNOPQR------\-STUVWXYZ------0123456789------
---------¢.«+I&---------!S~);~-I--------: ,X_>?---------' :~@I="-abcdefghi-------jkLffinoP'r-----I--stuvWXyZ--·
(ABCDEFGHI------)JKLMNOPQR-----~\-STUVWXYZ------0123456789-----­
---------¢.«+I&---------!S~);~-I--------:,X_>?---------' :~@I="-abcdefghi-------jkLffinoP'r-----I--stuvwxyZ-­
(ABCDEFGHI------}JKLMNOPQR------\-STUVWXYZ------0123456789------
e. Press the Stop switch to stop printing and to
turn off the Ready light. The print head will
return to the left margin area.
f. Set the Status switch to the Normal position
(the Data Cleared and Transparent Mode lights
come on.)
g. Set the Power switch to the Off position.
This is the end of Section 1. If all the steps in the
procedure were completed successfully, you are ready
for Section 2, which contains instructions for connecting
the printer to the system.