Table of Contents
Advertisement
The tools and test equipment needed to service the IBM
5256 Printer are listed below:
General logic probe kit
Standard CE tool kit
Metric tool kit
General Logic Probe
The general logic probe with needed leads and probe
tips is available in a kit from Mechanicsburg by ordering
part 453212.
Information specific to the use of this probe on the
printer is in 196. Refer to the instruction book shipped
with the probe for a description of the probe and its
operation.
Standard CE Tool Kit
Tools normally used by the CE are in this kit.
Metric Tool Kit
A kit of metric tools is available from Mechanicsburg by
ordering bill of material 1749235.
Note: In the 5256 all metric screws are blue.
PM, Tools
Tools and Test Equipment
~~UP
(@~DOWN
TECHNOLOGY
MULTI
~
MST
2/4 -
MST 1
LATCH
UP~
NONE
-
DOWN
GATE REF
+1.4V
~
GND -
-1.3V
GATING
+@
-@
Tools and Test Equipment
5256 MIM
3-1
Advertisement
Table of Contents
